Filter
Top Products
102
Using the PDBK-102 MPEG-TS Input/Output Board
Chapter 7 Using Option Boards
• Install the PDBK-101 in option slot 1.
• Make network settings in the network settings menu.
This menu appears only when the PDBK-101 option
board is installed.
Refer to the PDBK-101 operation manual for more
information about the network settings menu.
For safety, do not connect a peripheral device connector
that might have excessive voltage to the network connector
of this unit.
Follow the instructions in this manual when making
connections.
Using the PDBK-102
MPEG-TS Input/Output
Board
With the PDBK-102 MPEG-TS Input/Output Board
installed in option slot 2 of this unit, you can make i.LINK
connections between this unit and video devices
complying with the HDV 1080i
1)
standard (called “HDV
devices” below), and between this unit and computers to
which HDV devices may be connected. These connections
can be used for input and output of MPEG-2 TS streams.
This allows you to input material shot by HDV camcorders
or the results of editing on a computer, and to record the
input on XDCAM discs. You can also output video and
audio from this unit to HDV devices.
1) HDV and are trademarks of Sony Corporation and Victor
Company of Japan, Limited.
HDV Connection Example
The following example shows a connection between this
unit and an HDV camcorder.
• Install the PDBK-102 in option slot 2.
Notes
Caution
PHONES
VAR
JOG
MARK1
MENU
PAGEDISPLAY
SUB
CLIP
F1
F5
F4
F3
F2
SHIFT
CLIP
MENU
ESSENCE
MARK
SET
THUMB
NAIL
RESET
OUTIN
MARK2
SHUTTLE
TOP
KEY INHI
EXPAND
CHAPTER
F REV F FWD
END
PREV NEXTPLAY STOP
STANDBY
REC
EJECT
CH 1 CH 2 CH 3 CH 4
NETWORK
LOCAL
REMOTE
ACCESS
LEVEL
REC
VARIABLE
PRESET
PB
Laptop computer
Network cable (not supplied)
To network
connector
To network connector (GbE)
PDW-F70
Set the remote control switch to “NETWORK”.
Notes
PHONES
VAR
JOG
MARK1
MENU
PAGE DISPLAY
SUB
CLIP
F1
F5
F4
F3
F2
SHIFT
CLIP
MENU
ESSENCE
MARK
SET
THUMB
NAIL
RESET
OUTIN
MARK2
SHUTTLE
TOP
KEY INHI
EXPAND
CHAPTER
F REV F FWD
END
PREV NEXTPLAY STOP
STANDBY
REC
EJECT
CH 1 CH 2 CH 3 CH 4
NETWORK
LOCAL
REMOTE
ACCESS
LEVEL
REC
VARIABLE
PRESET
PB
HDV camcorder
S400 connector (6-pin)
PDW-F70
i.LINK connector (4-pin)
i.LINK cable (not supplied)