Filter
Top Products
93
System Menu
Chapter 6 Menus
AUDIO CONTROL [Audio]: Settings related to audio
control
Description
REC MODE [> REC mode]: Select the audio recording mode. *4ch×16bit [>> 4ch/16bit]: 4-channel, 48-kHz mode
2ch×16bit [>> 2ch/16bit]: 2-channel, 48-kHz mode
DATA MODE [> Data mode]:
Specify whether to handle
digital audio signals as
non-audio signals during
recording.
CH1/CH2 IN [>> CH1/CH2]:
Specify for the input to
the DIGITAL AUDIO
(AES/EBU) 1/2
connectors.
*AUDIO [>>> Audio]: Handle as audio signals.
DATA [>>> Data]: Handle as non-audio signals.
CH3/CH4 IN [>> CH3/CH4]:
Specify for the input to
the DIGITAL AUDIO
(AES/EBU) 3/4
connectors.
LEVEL SELECT
[> Level Sel]
REF LEVEL [>> REF Level]:
Specify the reference
level (headroom) for
audio signals recorded to
disc.
*–20dB [>>> –20dB]
–18dB [>>> –18dB]
–16dB [>>> –16dB]
–12dB [>>> –12dB]
CH1 IN LEVEL [>> CH1
input]: Select the audio
level setting according to
the audio level of the
signal input to the AUDIO
INPUT 1/3 connector.
*+4dB [>>> +4dB]
0dB [>>> 0dB]
–3dB [>>> –3dB]
–6dB [>>> –6dB]
CH2 IN LEVEL [>> CH2
input]: Select the audio
level setting according to
the audio level of the
signal input to the AUDIO
INPUT 2/4 connector.
OUTPUT LEVEL [>> Out
Level]: Select the analog
audio output reference
level.
INT AUDIO SG [> Audio SG]: Select the operation of the
internal audio test signal generator. When you set A1
INPUT to A4 INPUT in the HOME page of the function
menu to “SG”, the internal signal generator is activated
and outputs the selected test signal. You can record this
signal.
SILENCE [>> silence]: Silent signal
*1kHz SINE [>> 1kHz]: 1-kHz, –20 dB FS sine wave signal
SHUTTLE MUTING [> Shtl muting]: Set the audio muting
conditions during shuttle playback.
*OFF [>> OFF]: Do not perform muting.
ON [>> FULL]: Perform muting.
EDIT POINT [> Edit Point]: Specify the type of editing for
audio signals.
CUT [>> Cut]: Cut editing (Discontinuity in audio signal may
result at the editing point, causing noise during playback.)
*FADE [>> Fade]: Fade in and fade out
DV OUT MODE [> DV out mod]: Select the audio output
mode of the S400 connector.
4ch [>> 4ch]: 12 bit/32 kHz/4ch
*2ch [>> 2ch]: 16 bit/48 kHz/2ch
INTERFACE SELECT [Interface]: Settings related to
interfaces
Description
D-SUB OUTPUT [> D-SUB Out]: Select the format of the
signal output from the MONITOR connector.
XGA(SYSTEM) [>> XGA(SYS)]: Set to XGA monitor output
(according to system frequency).
*XGA(60Hz) [>> XGA(60Hz)]: Set to XGA monitor output
(fixed at 60 Hz).
YPbPr [>> YPbPr]: Y/R–Y/B–Y component video signals
IN OUT