Filter
Top Products
34
24P (23.98P) Mode Settings
Chapter 2 Preparations
14
Press the m/MARK2 button to select “23.98P”.
15
If you want to change the monitor output setting as
well, press the </IN button to return to the higher
level screen (the state of step 11). If you do not want
to change the monitor output setting, proceed to step
19.
16
Press the m/MARK2 button to select “23.9P
OUTPUT”.
17
Press the ,/OUT button.
The setting value appears.
18
Press the M/MARK1 or m/MARK2 button to select
one of the following.
23.98PsF: Output as 23.98P.
2-3 PULL DOWN: Output after pulldown conversion
to 59.94i.
19
Press the SET button.
A confirmation message appears.
20
Press the SET button to confirm the changes, or the
RESET button to cancel them.
If you have pressed the SET button, power the unit off
and on again to enable the changes.
Input and Output Signals in 24P
(23.98P) Mode
The following tables show the signals input and output by
the unit when “23.98PsF” and “2-3 PULL DOWN” are
selected.
Input and output signals
SETUP MENU
OPERATIONAL FUNCTION
SYSTEM SEL
SYSTEM FREQ : 601
* 60I
50I
30P
25P
23.98P
SETUP MENU
OPERATIONAL FUNCTION
SYSTEM SEL
23.9P OUTPUT: PsF
* 23.98PsF
2-3 PULL DOWN
I/O Type 23.98PsF 2-3 PULL
DOWN
Input
signals
Reference
video input
23.98PsF
reference signal
59.94i
reference signal
HDSDI input 23.98PsF video and audio
signals
Input
timecode
LTC input 24-frame timecode
HDSDI LTC
input
Output
signals
HDSDI
output
23.98PsF video
and audio
signals
Video and
audio signals
pulled down to
59.94i
SDSDI output No output
Composite
output
i.LINK DV
output
i.LINK TS
output
Timecode
output
LTC output 24-frame
timecode
30-frame
timecode after
pulldown
conversion
HDSDI LTC/
VITC output
SDSDI
RP188 LTC
output
–
SDSDI VITC
output
–
COMPOSITE
VITC output
–