Filter
Top Products
36
24P (23.98P) Mode Settings
Chapter 2 Preparations
The values of “24F TC” and “30F TC” under TIME CODE
>PD PRESET in the setup menu are used as the conversion
references.
To display 30-frame pulldown timecode in the
monitor video display section or on an external
monitor
1
Press the MENU button.
The system menu (see page 83) appears.
2
Press the M/MARK1 or m/MARK2 button to select
SETUP MENU.
3
Press the ,/OUT button.
The setup menu appears.
4
Press the M/MARK1 or m/MARK2 button to select
“DISPLAY CONTROL”.
5
Press the ,/OUT button.
The second level of the DISPLAY CONTROL menu
appears.
6
Press the M/MARK1 or m/MARK2 button to select
“DISPLAY INFO”.
7
Press the ,/OUT button.
The third level of the menu appears.
8
Press the M/MARK1 or m/MARK2 button to select
“TIME DATA ONLY”.
9
Press the SET button.
The setting is confirmed.
10
Turn the display of character information on.
For details, see “To turn superimposed text on and
off” (page 37).
As shown below, you can display 24-frame timecode
at the same time as 30-frame pulldown timecode.
SETUP MENU
OPERATIONAL FUNCTION
DISPLAY CONTROL
SETUP BANK OPERATION
MENU GRADE :BASIC
SETUP MENU
DISPLAY CONTROL
CHARA.DISPLAY
CHARA.POSITION
CHARA.TYPE
CHARA.VSIZE
DISPLAY INFO
SUB STATUS
MENU DISPLAY
BRIGHTNESS
ALARM
:ON
:WHITE
:x1
:T&STA
:OFF
:WHITE
:55%
:ON
SETUP MENU
:T&STA
DISPLAY CONTROL
DISPLAY INFO
* TIME DATA & STATUS
TIME DATA & UB
TIME DATA & CNT
TIME DATA & TIME
TIME DATA & CLIP
TIME DATA ONLY
LTC 00:59:59:23
PDT 00:59.59:28