Filter
Top Products
97
Additional Information
Recording does not stop immediately
after you press x REC STOP.
, It will take a few seconds for the recorder to
input disc data before recording can stop.
On-screen instructions may appear after
pressing x REC STOP. In this case, follow
the on-screen instructions.
Recording does not stop after you press
x.
, Press x REC STOP.
Timer recording is not complete or did not
start from the beginning.
, There was a power failure during recording.
If the power recovers when there is a timer
recording, the recorder resumes recording.
Should the power failure continue for more
than 1 hour, reset the clock (page 75).
, Another timer setting overlapped the timer
setting (page 48).
, Disc space was not sufficient.
, The VPS/PDC function is working.
Contents previously recorded were
erased.
, Data that is not playable on this recorder but
was recorded on a DVD with a PC will be
erased from the disc when the disc is
inserted.
The VPS/PDC function does not operate.
, Check that the clock and date are set
correctly.
, Check that the VPS/PDC time you set is
correct (there might be a mistake in the TV
programme guide). If the broadcast you
wanted to record did not send the correct
VPS/PDC information, the recorder will not
start recording.
, If the reception is poor, the VPS/PDC signal
might be altered and the recorder might not
start recording.
Nothing was recorded even though you set
the Synchro-Recording setting correctly.
, You forgot to turn off the connected
equipment. Turn off the connected
equipment and set the recorder to Synchro-
Recording standby mode (page 49).
, The recorder was not set to the Synchro-
Recording standby mode. Set the recorder
to stand by for Synchro-Recording. Make
sure the SYNCHRO REC indicator lights
up in the front panel display (page 49).
, The equipment is not connected to the LINE
1/DECODER jack of the recorder.
, The recorder is connected to the TV output
jack of the connected equipment.
, The Synchro-Recording and another timer
recording overlap (page 50).
Synchro-Recording does not complete.
, The timer setting for the connected
equipment overlapped the recorder’s timer
setting (page 50).
, There was a power failure during the
recording.
, The [/1 button was pressed before
Synchro-recording started.
The recorder automatically starts recording
when the satellite receiver is turned on.
, The Synchro Rec function was activated.
Turn off the satellite receiver and cancel the
Synchro Rec function (page 49).
The clock has stopped.
, Set the clock again (page 75).
, The clock stopped due to a power failure
that lasted for more than 1 hour. Reset the
clock (page 75).
The timer indicator is flashing.
, The disc does not have enough space.
, Insert a recordable disc into the recorder.
, The inserted DVD is protected (page 36).
Recording from the connected
equipment with a timer
Display
,continued