Filter
Top Products
67
20.2.2. "Restart" Warning Display
If all of the connected hard disk drives (including expansion units)
experience an error, then the warning message shown at right is
displayed.
Press the power key continuously for two seconds or more to cut
the power, then press the key again to restart.
20.2.3. Checking Hard Disks When an Error Has Occurred
The menu can be used to check hard disk drive initialization. If a
hard disk error occurs when hard disk drives are connected,
"
-----
" is displayed.
(Refer to p. 102; Hard Disk Drive Initialization.)
20.2.4. If a Hard Disk Error Occurs
If the disk drive is the Digital Video Recorder's:
• Restart the power.
Note
If the drive is restored by restarting the power, then some of the recorded data may be lost. Copy any
necessary data to another location and initialize the disk.
• If the error persists even after restarting the power, then initialize the disk.
Note
Initializing the disk will cause all video and other data stored on it to be erased.
Copy any necessary data to another location and initialize the disk.
• If the error persists even after the disk has been initialized, then it is necessary to replace the hard disk
drive. Consult your TOA dealer for more information.
AN ERROR HAS BEEN DETECTED
ON THE HARD DISK.
PLEASE REACTIVATE USING
THE POWER KEY.
HD INITIALIZE
DISK MODE NORMAL
EXECUTE EXECUTE
HDD–A MASTER 160GB SLAVE
-----
HDD–B MASTER
-----
SLAVE DVD
N
O
R
M
A
L
Error occurs