Filter
Top Products
95
CTRL OUTPUT SETTING
OUT T IME
PRIORITY REC INVALID –
ALARM REC CTRL1 REC IN
MOTION REC CTRL3 REC IN
HD FULL CTRL2
HD ERROR CTRL3
VIDEO LOSS CTRL4
FAN FAILURE CTRL4
I
N
V
A
L
I
D
Item Selection Description
PRIORITY REC OUT Set the terminal that outputs a control signal when Priority
Recording occurs.
REC IN: Outputs a control signal for the duration of
Priority Recording.
1 SEC: Outputs a control signal for 1 second when
Priority Recording begins.
REC IN: Outputs a control signal for the duration of
Alarm Recording.
1 SEC: Outputs a control signal for 1 second when
Alarm Recording begins.
REC IN: Outputs a control signal for the duration of
Motion Detection Recording.
1 SEC: Outputs a control signal for 1 second when
Motion Detection Recording begins.
Set the terminal that outputs a control signal when
Alarm Recording occurs.
ALARM REC
CTRL 1 / CTRL 2 / CTRL 3
/ CTRL 4 / INVALID *
1
REC IN / 1 SEC
REC IN / 1 SEC
REC IN / 1 SEC
Set the terminal that outputs a control signal when
Motion detection Recording occurs.
MOTION REC
Set the output terminal that outputs signals when the
remaining hard disk capacity falls lower than the available
recording time.
HD FULL
Set the terminal that outputs a control signal when a hard
error occurs.
HD ERROR
Set the terminal that outputs a control signal when
Video Loss occurs.
VIDEO LOSS
Set the terminal that outputs a control signal when
Fan failure occurs.
FAN FAILURE
*
1
Time cannot be selected if the output terminal setting has been set to “Invalid.”
Note:
Underlined settings represent factory-preset settings.
CTRL 1 / CTRL 2 / CTRL 3
/ CTRL 4 / INVALID *
1
CTRL 1 / CTRL 2 / CTRL 3
/ CTRL 4 / INVALID *
1
CTRL 1 / CTRL 2 / CTRL 3
/ CTRL 4 / INVALID
CTRL 1 / CTRL 2 / CTRL 3
/ CTRL 4 / INVALID
CTRL 1 / CTRL 2 / CTRL 3
/ CTRL 4 / INVALID
CTRL 1 / CTRL 2 / CTRL 3
/ CTRL 4 / INVALID
TIME
OUT
TIME
OUT
TIME
27.2. Control Output Terminal Setting
The Digital Video Recorder can output a control signal at the
time of occurrence of Priority Recording, Alarm Event
Recording or equipment failure. There are 4 control output
terminals. Set the terminals that output the control signal.