Filter
Top Products
Chapter 1 Getting to Know Your NSA
NSA210 User’s Guide
27
1.4.1 COPY/SYNC Button
Use the COPY/SYNC button on the front panel to copy or synchronize files
between a connected USB device and the NSA. See Section 9.10 on page 196 for
more details on how to configure the copy/sync settings.
1.4.2 RESET Button
Use the RESET button on the rear panel to restore the NSA’s default settings.
Figure 4 The RESET Button
•Press the RESET button until you hear one beep (after about two seconds),
then release it. You will hear one more beep after you release the button.
This resets the NSA’s IP address and password to the default values.
USB Green On The hard disk drive is connected properly to the NSA.
Blinking The NSA is saving data to the hard disk drive.
Red On The hard disk drive has failed and the NSA can no longer
detect it.
Off No USB device connected to the USB port.
eSATA Green On The hard disk drive is connected properly to the NSA.
Blinking The NSA is saving data to the hard disk drive.
Red On The hard disk drive has failed and the NSA can no longer
detect it.
Off No eSATA hard disk connected to the eSATA port.
COPY Green On A USB device is connected to the NSA.
Blinking The NSA is copying or synchronizing files to or from the
USB device.
Red On Copying or synchronizing files to or from the USB device
failed.
Off No USB device is connected.
Table 1 LEDs (continued)
LED COLOR STATUS DESCRIPTION
Press
1 Beep
2 Beeps
IP Address
Password
Clear All Settings
5 more seconds
Release to
Release to Reset