Filter
Top Products
Chapter 2: SNMP Configuration
26 Installing and Configuring the Avaya S8400 Media Server February 2006
Because the SNMP module is manufactured by a third party, we do not know which brand,
model, or firmware load the factory is shipping. Therefore, we cannot provide specific
instructions in this document on how to connect to and configure the SNMP module. See the
documentation that comes with the SNMP module. The default password and the configuration
commands are in the local configuration section of the User Guide.
Default UPS IP addresses
Administer the SNMP module in the UPS following the steps in Administering the SNMP
module on page 27. The default IP addresses for the UPS are shown in the table.
Preparing to configure the SNMP module
Before you configure the SNMP module, make sure you have the hardware connected correctly
and all the information you need.
● Ensure you are plugged into the correct administration port on the SNMP module.
● Ensure the UPS is plugged into a nonswitched electrical outlet.
Note:
Note: Avaya Terminal Emulation and HyperTerminal are supported terminal emulation
applications.
● When using your terminal emulation application, ensure that your laptop communication
protocol has the following port settings:
-
9600 baud
-
No parity
-
8 data bits
-
1 stop bit
-
No flow control
IP address for UPS 198.152.254.239
Subnet mask for UPS 255.255.255.0
Gateway address for UPS 198.152.254.201
IP address for
Trap receiver (media server)
customer provided