Filter
Top Products
WEB OPERATION QC40198 User Manual
104 | Page
PTZ
PTZ interface is shown in Figure 7-48
Please note, before operation make sure you have set speed dome address, and combo DVR and speed dome
connections are OK.
Figure 7-48
Please refer to the following chart for detailed information.
Parameter Function
Channel
You can select monitor channel from the dropdown list. .
Protocol
Select the corresponding dome protocol.(such as PELCOD)
Address
Set corresponding dome address. Default value is 1. Your setup here
must comply with your dome address; otherwise you can not control
the speed dome.
Baud
Rate
Select the dome baud rate. Default setup is 9600.
Data Bit Default setup is 8. Set according to the speed dome dial switch setup.
Stop bit
Default setup is 1. Set according to the speed dome dial switch setup.
Parity Default setup is none. Set according to the speed dome dial switch
setup.
Save You can click save button after you complete setup for one channel,
or you can complete the whole setup and then click save button.
Refresh Click this button to get device’s latest configuration information.