Filter
Top Products
2
2-14
EMC Fibre Channel Disk-Array Processor Enclosure (DPE) Hardware Reference
Installing a Rackmount DPE
• Avoid tight bends. If you need to make a 90º bend, do it over 6
to 12 inches.
• Do not use optical cables to support weight. That includes
long cable runs without support.
• Do not pull long runs of cable. It is best to lay the cable in
place or pull only a few feet at a time.
• Run the cables so that they are not stepped on or rolled over
by anything.
Figure 2-9 Attaching Optical Cables to a DPE
B
A
Fibre optic cable
Cover
Optical GBIC
connector
Cover
A. Remove the protective covers
from each optical GBIC
connector and each fibre
optic cable.
B. Plug the fibre optic cable into
Port A and/or Port B on the
SP.