Filter
Top Products
3
3-14
EMC Fibre Channel Disk-Array Processor Enclosure (DPE) Hardware Reference
Servicing and Upgrading a DPE
Replacing the SP Fan Pack
CAUTION
!
Handle a fan pack gently and use an ESD wristband. Do not
remove a faulty fan pack until you have a replacement available.
You can remove the fan pack while the DPE is powered up. If the
pack is removed for more than about two minutes, the SPs and disk
modules power down. The SPs and disk modules power up when
you reinstall the SP fan pack.
Removing the SP Fan
Pack
1. At the front of the DPE, grasp the SP fan pack cover at its sides
and pull it from its ballstud mounts as shown below.
Figure 3-7 Removing the SP Fan Pack Cover
2. Remove the fan pack as shown next.
Ballstud