Filter
Top Products
3
3-44
EMC Fibre Channel Disk-Array Processor Enclosure (DPE) Hardware Reference
Servicing and Upgrading a DPE
4. Plug the ac line cord into the new supply, and turn on its power as
shown below.
5. Reinstall the drive fan pack as shown on page 3-35.
Figure 3-33 Plugging in the AC Line Cord and Turning on Power
Bottom power supply
Top power supply
Power switch
ac inlet
ac inlet
Power switch
Channel
ac power cord
(right-angle plug)
a. Plug the right-angle plug on the ac line cord into the supply’s ac inlet.
For each power supply
d. Route the cord along the power supply to the side of the enclosure.
c. Bend the cord into a U shape and slide the U into the channel so the end of the
cable comes out of the channel at the back of the enclosure.
The cord must not occupy the space for the drive fan pack.
d. Plug the end of the cord into one of the cabinet’s power outlets.
e. Set the supply’s power switch to the on (1) position.