Filter
Top Products
3
3-34
EMC Fibre Channel Disk-Array Processor Enclosure (DPE) Hardware Reference
Servicing and Upgrading a DPE
Figure 3-23 Reconnecting a Copper Cable to an Expansion LCC
3. You have replaced the LCC. Remove and store the ESD
wristband.
Replacing the Drive Fan Pack
CAUTION
!
Handle a fan pack gently and use an ESD wristband. Do not
remove a faulty fan pack until you have a replacement unit
available. You can remove the fan pack while the DPE is powered
up. If the pack is removed for more than approximately two
minutes, the SPs and disk modules power down. The SPs and disk
modules will power up when you reinstall the drive fan pack.
Copper cable
B.
Tighten the two screws
on the cable's connector.
A.
Plug the copper cable
into the LCC connector.