Filter
Top Products
3
3-38
EMC Fibre Channel Disk-Array Processor Enclosure (DPE) Hardware Reference
Servicing and Upgrading a DPE
Figure 3-27 Removing the Top Filler Module
3. Install a power supply in the empty slot as explained on
page 3-41.
Removing a
Power-Supply Module
CAUTION
!
Turn off the power supply before unplugging the ac line cord from
the supply or removing the supply from the enclosure.
1. Remove the drive fan pack, as shown on page 3-35.
2. Turn off the power supply and unplug its ac line cord as shown
next.
Latch
(one per side)
Top filler module
A. Push the latches on both sides of the
filler module towards the center.
B. Pull the filler module
from the slot.