Filter
Top Products
3 - 8
3 Connecting the Memory Card Recorder
Connecting the Memory Card Recorder with the POD
Connecting the UG00P-MR with the POD
“Screen data transmission” and an “external storage
device (functions for data logging and memory manager)”
can be used when connecting the UG00P-MR with the
POD.
Connect the UG00P-MR with the POD as shown in the
figure on the right.
External Storage Device (data logging and memory manager)
•
To use MJ2 (MJ1) for an external storage device, specify [Memory Card] for [Modular Jack 2] ([Modular
Jack 1]) at [Modular] in [System Settings] on the editor.
•
To use data logging or memory manager with modular jack 1, set DIP SW6 to ON (termination resistor:
Enabled) at the back of the POD.
Transferring Screen Data between the UG00P-MR and POD
•
To use MJ1 to transfer screen data, specify either [Editor Port], [Memory Card], or [Barcode] for the
[Modular Jack 1] setting on the editor.
To use MJ2, specify [Modular Jack 2] for [Memory Card]. MJ2 takes priority, and data transmission from
MJ1 is prohibited.
•
For how to transfer POD screen data to the memory card or how to transfer screen data recorded in the
memory card to the POD, see Section 1, “17. POD Operation.”
Connecting the Memory Card Recorder with PC
To write screen data to or read screen data from the
UG00P-MR using a personal computer, or to read/
write data using memory manager or data logging,
connect the UG00P-MR with the PC as shown on the
right.
•
Before reading/writing screen data, be sure to start up UG00S-CW (screen development software) on the
PC. For the procedure, refer to the User's Manual <Operation> (FEH375).
•
Before reading/writing data using memory manager or data logging, be sure to start up UG00P-MSE. For
the details of UG00P-MSE, refer to the User's Manual <Memory Card Editor> (FEH359).
CN2
MJ1MJ2
C
N
1
100-
240VAC
L
N
NC
Memory card
The UG00P-MR
AC adapter is
not required.
Cable contained
in the package
Connect the cable
to MJ1 or MJ2.
RESET
disc
Memory card
Connect the
UG00P-MR AC
adapter.
AC adapter
UG00C-T
PC
Connect the cable
to COM1 or COM2.