Filter
Top Products
3 - 16
6 Connecting the Dual Port Interface
How to install UG00P-DI
To connect the UG00P-DI to A series PLC of small type (A1S, A2US, etc.), it is necessary to mount the
bracket that is supplied with the UG00P-DI.
MELSEC Axsxxx
MITSUBISHI
POWER
MELSEC AxS
CPU
RUN L.CLR
ERROR RESET
RUN
STOP
RESET
MITSUBISHI
MELSEC Axsxxx
MITSUBISHI
POWER
MELSEC AxS
CPU
RUN L.CLR
ERROR RESET
RUN
STOP
RESET
MITSUBISHI
GPP
UG00P-DI
UG
GPP
Not used
Surely tighten
the screws.
Fit the bracket
according to the
figure at right.
Surely tighten the
screw after mounting
the bracket.
50
16.3
6.5
[Dimensions of
the bracket]
(Used to connect to A or
QnA series of large type)
(Unit: mm)
UG00P-DI
UG
1 2 3
1 2 3
G
D
G
P
P
UG00P-DI
U
G
U
G
0
0
P
-
D
I
1
2
3
1
2
3
U
G
0
0
P
-
D
I
UG00P-DI
CPU
Personal computer, A6GPP, A7PHP, etc.
POD
UG520/420/320/221/220
UG400/210
When connecting to A series or QnA series CPU,
insert the connector provided on the rear
directly to the CPU port, or use UG200C-G
(sold separately).
When connecting to FX1/2 series CPU, use
UG200C-G (sold separately).
When connecting to FX0N/2N series CPU, use the
conversion cable (FX-20P-CADP) supplied
from Mitsubishi.
Mitsubishi A/QnA/FX series
Connector for GPP
(can be used to connect
POD)
Connector
for POD
Connector for
CPU port
Enlarged view
GPP
Sliding switch
Used to select the model of
connected device.
1. A series (ACPU port)
2. QnA series (QnACPU port)
3. FX series
Note:
Be sure to turn the power off
when changing over of the
sliding switch.
UG200C-M
UG200C-G (sold separately).
How to Use UG00P-DI
1) To use for debugging
Connect to POD or GPP (personal computer, A6GPP, etc.)
2) To use for connecting two units of POD
PODs can be connected on the GPP side as well as on the UG side (see the above figure).
For this, the cable used on the GPP side must be the same as that used on the UG side (UG200C-M).
Precautions for Use
1. Be careful of the capacity of the 5V power supply of the CPU because the UG00P-DI is supplied power
from the CPU (current consumption: max. 350 mA).
2. The wiring length between the CPU and the UG00P-DI shall be as short as possible (max. 1 to 1.5 m).