Filter
Top Products
2 - 25
8 MITSUBISHI PLC • 2
Notes on using UG00P-DI (Dual Port Interface)
As the UG00P-DI is powered by a CPU, check that the electric capacity of the CPU is at 5V (power
consumption: max. 350mA).
The distance between the CPU and the UG00P-DI should be as short as possible (max. 1 to 1.5m).
For wiring, take appropriate measures to eliminate noise.
Specify the value more than 150 (=1.5 sec) in [Time-out Time] of [Comm. Parameter] in case of
connecting POD to a UG00P-DI.
CPU
PLC
A6GPP, A7PHP, personal computer, etc.
G
D
G
P
P
UG200C-G
Slide switch
1 • • • A series
2 • • • QnA series
3 • • • FX series
*
Note:
Be sure to turn the power off
when changing over of the
sliding switch.
POD
MITSUBISHI A/QnA
Series.
1
2
3
In case of direct connection with the
CPU port of A/QnA series,
plug the rear connector of UG00P-DI
in the CPU port, or use the cable
"UG200C-G" made by Fuji Electric.