Filter
Top Products
1 - 31
Bar Code Reader Interface
12
It is possible to receive the signal from a bar code reader by connecting a bar code reader to POD via the
modular jack (MJ1/MJ2) of POD series.
To connect a bar code reader to POD via MJ1/MJ2, use the cable which is the optional equipment made
by Fuji Electric. Co., Ltd. (UG00C-B).
Length : 3m
Accessory : Modular Plug
Notes on Connection
•
In case of using the bar code reader which uses the CTS and RTS control, the bar code reader may not
work normally without jumping RTS and CTS.
•
The output power supply (+5V) is max. 150mA. (Refer to the preview page.)
When the bar code reader connected to UG400 is used, connect it to UGx20 by the following cable.
Pin No.
1
2
3
4
5
6
7
8
9
Signal
CTS
RXD
TXD
RTS
SG
+5V
Red : 0V
Orange : RXD
Yellow : TXD
Brown : +5V
*
Jump pins, 1(CTS) and 4(RTS).
Signal
RTS
TXD
RXD
CTS
SG
+5V
Barcode Reader
*
12345678
D-sub 9pin
()
Red : 0V
Orange : RXD
Yellow : TXD
Brown : +5V
12345678
12 Bar Code Reader Interface