Filter
Top Products
104
Additional Information
Disc cover cannot be
closed.
Is the disc correctly inserted?
Remove the disc and then reinsert it.
23
Connect a fully charged battery or AC adapter/charger,
and then turn the camcorder on and try again.
18, 25
Operating noise is
heard.
This is not a fault. A quiet operating sound is heard as the
disc rotates during recording or playback, etc.
—
Some vibrations are
felt or slight sound is
heard from
mechanism.
These vibrations or sound are caused by HDD/disc drive.
This does not indicate a fault.
—
• No operation can
be performed
because the
ACCESS indicator
on this camcorder
remains lit or
flashing.
• After a disc or
card is inserted, it
takes some time
until recording is
possible.
In the following cases, it will take more time than usual
until operation is possible:
• Immediately after a disc is inserted.
• When a long time has elapsed since the camcorder was
turned off last.
• When the temperature is greatly different from the
status of previous recording.
• When a scratched or dirty disc is inserted.
• When the camcorder is subjected to strong vibrations.
• When the battery or DC power cord was disconnected
before turning the power switch off.
—
No image appears on
the LCD screen.
• Is the camcorder connected to a PC with a USB cable?
Disconnect the USB cable.
• In playback mode, did the last scene viewed end in a
wipe to black edit?
Press .
68, 81
Symptom Cause and Correction
Reference
page