Filter
Top Products
FUSION DVR Digital Recording and Transmission System
5–38
5.14 CENTRAL USER MANAGEMENT, CONTINUED
5.14.5 ENABLING A DVR TO USE CENTRAL USER MANAGEMENT
To enable a DVR to use the Central User Management software follow these steps
1. Select the
button from the User Management Window.
2. Place a Check in the Enable User Central Management box.
3. Enter the IP address of the Authentication Server running the Central User
Management software.
4. Enter the Server Port used by the Authentication Server. (Must be between 7000-
7100)
5. Enter a Site port that the DVR will use to communicate with the Authentication
Server. (Must be between 6000-6100)
6. Press OK to save and close.
5.15 TV OUTPUT CONTROL SETUP (OPTIONAL)
The 4 Channel TV Output Card allows selectively of each of the four video outputs to
an analog device (such as a TV Monitor).
This device supports multiple features such as:
• Camera Selectable Single Channel Sequencing
• Output based on Sensor activation
• Output based on Motion detection
• 4 outputs – each customizable.
With the addition of the 4 Channel Output card, the selection of individual cameras to
display is available. This allows versatility and flexibility in displaying cameras where
they need to be viewed.