Filter
Top Products
41
Using the Main Menu
Alarm
The Alarm tab allows you to
configure Motion Detection
settings.
Configuring Motion Detection
Configure motion settings to determine
the area you wish to monitor for motion
events, and the outcome if a motion
event occurs.
To configure motion settings:
1 Se
lect the Motion tab.
2 Co
nfigure the following:
• Channel:
Select the channel you wish to
configure.
• Ena
ble: Select Enable or Disable to
activate or deactivate motion recording.
• Ar
ea: Click the Setup button to configure
the area of the screen that detects motion.
• Se
nsitivity: Select motion sensitivity. The
greater the number, the greater the
sensitivity.
• Sh
ow Message: Select the checkbox if you
want the system to display a system
message when an alarm triggers.
• Buz
zer: Select the duration the system
will "beep" when motion is detected. Or
select OFF to disable the "beep" during
motion events.
• Send Email: Sel
ect the checkbox if you
want the system to send email
notifications if an alarm triggers. Email
notifications must be configured.
• Rec
ord Channel: Select the channel you
wish the DVR to record during motion
recording.
• Fu
ll Screen: Select the Full Screen check
box so that the system goes into full screen
mode when motion is detected.
• Po
st Recording: Enter the post recording
duration (the time the system continues to
record after a motion event occurs).
3 Click Apply t
o save your settings.
Drag mouse cursor
over desired area
Click and drag the mouse cursor to configure motion
detection areas. Motion detection is enabled in red areas
and disabled in transparent areas. Right-click to exit.