Filter
Top Products
19
4. Connection with external equipment (RS-232C Interface)
4 Connection with RS-232C equipment
, When connecting the unit with another equipment, make sure to set the power of each equipment to “OFF”.
Setting BAUD RATE
Set the baud rate of this unit according to the equipment to be connected.
, As to the baud rate of the equipment connected, refer to the operation manual of the equipment connected.
Displaying the menu screen
,
The baud rate is set on the menu displayed on the monitor screen or LCD. (The following is an example of display on LCD.)
, Make sure to turn off the power before setting.
Displaying “Memory SW Main Menu”
1 Press the POWER button while pressing the MEMORY button on the
front panel.
, The menu for memory switch, “Memory SW Main Menu” is displayed.
Displaying “System Set Menu”
} Use the buttons on the remote control to display and set this menu.
2 Press the DOWN button to select “5. SYSTEM SET : PUSH
[ ] ]” .
3 Press the RIGHT button.
, The menu for signal setting, “System Set Menu” is displayed.
, Set “BAUD RATE” on this menu.
Memory SW Main Menu
1.TIME ADJ :PUSH[>]
Memory SW Main Menu
5.SYSTEM SET:PUSH[>]
System Set Menu
PRG ALL INIT : OFF
AC LINE
R G/G+SYNC B H+V-SYNC
R G/G+SYNC B H+V-SYNC
IN
OUT
S-VIDEO
VIDEO
75Ω
HIGH
75Ω
HIGH
IMPEDANCE
SYNC.
RGB
RS-232C
To RS-232C port
(RS-232C)
To RS-232C port
VCP
Equipment with RS-232C
REMOTE
12