Mitsubishi Electronics CP700E VCR User Manual


 
85
9. Troubleshooting
Other messages
MECHA INITIALIZE REQUEST
MECHA INITIALIZE
PRINT STOP
Indicated when the power is turned on after turning off during printing.
Press the MEMORY button for more than one second while pressing
the MONITOR button. *Note : 3
Indicated during initializing.
In the case of pressing the STOP button on the remote control during
printing, this unit is initialized. This message is indicated during initializing.
*Note : 3 This is an operation for initialization. Make sure to press the MONITOR button first. If the MEMORY
button is pressed first, a new image will be stored in memory erasing any previously stored image.
1 Overcoming paper jams
, Roll up the print paper completely.
1 Press the OPEN button to pull out the printing unit.
2 Remove the ink cassette.
3 Turn the knob on the right side of the printing unit clockwise.
4 Remove the print paper.
5 Cut the defective part of print paper with scissors.
6 Cut both edges of the print paper.
7 Install the print paper. ( Refer to pages 7 - 8.)