Filter
Top Products
46
7. Setting the functions (Main menu)
ANALOG ADJ The adjustment image of analog input signal display
, This menu is used to adjust the image of analog input signal display before storing in the memory.
, This menu is opened when pressing RIGHT
button on “ANALOG ADJ : PUSH [ ] ]” .
, When selecting RGB analog signal, “COLOR” “TINT” is not adjusted and displayed.
BRT (Bright )
Function
Adjust the brightness of printing image.
CONT (Contrast )
Function
Adjust the contrast of printing image.
R-SUB (Red-subcontrast)
Function
Adjust the red-subcontrast of printing image.
B-SUB (Blue-subcontrast)
Function
Adjust the blue-subcontrast of printing image.
COLOR
Function Adjust the color of printing image
, The each function and setting area is as follows.
Item Adjustment -32 Adjusting area +31
B R T Brightness Darker ............................. Brighter
CONT Contrast Less contrast ....................... More contrast
R-SUB Red-subcontrast Add cyan ........................... Add red
B-SUB Blue-subcontrast Add yellow ......................... Add blue
COLOR Color Light .............................. Deep
• When selecting the RGB signal, COLOR is not shown on the monitor display.
CENTER
Function The setting value of “COLOR ADJ” is initialized.
When this function is set to “ON” , the setting value of BRT, CONT, R-SUB , B-SUB, COLOR is reset to 0.
, When pressing the SET
SET
button after selecting “OK” on the lower position “CHANGE : OK/CANCEL” ,
“1.COLOR ADJ” menu is displayed.