Filter
Top Products
81
8. Printing Procedures (Special prints)
External REMOTE 2 terminal on the rear panel
The images can be stored in memory and printed by sending the remote signal through the external remote terminal on the rear
panel.
, Make out the necessary circuit to use this function by referring to the following.
1 External remote terminal Signal allocation Connector MINI DIN8PIN
Pin No.
1
2
3
4
5
6
7
8
Function
Ground
MEMORY
Unused
BUSY
PRINT
REMOTE
Unused
DC3V
Description
Earth
Memory: When the signal becomes “LOW” from “HIGH”, the image is stored in
memory. (When the signal has been “LOW” for 60msec. or more, the image is
stored in memory. )
“HIGH” : The VCP cannot accept the remote signal.
“LOW” : The VCP can accept the remote signal.
The signal becomes “HIGH” in the following cases;
(1) During initialization after the VCP has been switched on
(2) For about 1 sec. after the INPUT SELECT switch has been set
(3) During displaying the menu screen
(4) When the image cannot be stored in memory
PRINT :When the signal becomes “LOW” from “HIGH”, the image stored in
the memory is printed. (When the signal has been “LOW” for 60 msec. or
more, the image is printed.)
The same functions as the remote control can be controlled.∗
Power supply for the remote control DC 1mA MAX
∗Refer to page 82 for this function.
, When the signal from BUSY terminal is received with TTL level, keep the following.
| 1
OL
| =2mA or less, | 1
OH
| =1mA or less
| 1
OL
| shows the current flowing into the unit at Low output, | 1
OH
| shows the current flowing out of the unit at High
output.
Pin No.