Filter
Top Products
75
1 OPERATION
1 Setting the multi-print and photo-print menus
Setting multi-print and photo-print functions
1 Press the MENU button. Then, press the UP
or DOWN shift button to select “3. ADDITIONAL PUSH [ ]”.
3 Press the DOWN
shift button to select “MULTI : OFF/ON”. Then press the RIGHT shift button to select “ON” .
4 Set the multi-image type (2, 2s, 4 or 16) or photo print size.
, “MODE : SAME/DIFF/PHOTO” is displayed on the menu screen.
, “IMAGES : 2 / 2s/ 4/ 16” is displayed on the lower line.
, Set “MODE : SAME/DIFF/PHOTO” and “IMAGES : 2/2s/4/16 or CARD/3*4/5*5” menus.
, Refer to 1 MULTI PRINT and 2 PHOTO PRINT for the multi-image type.
2 Press the RIGHT
shift button to select “3. ADDITIONAL”.
1 Setting the SEPARATE function
5 Press the DOWN shift button to select “SEPARATE : OFF/ON” .
6 Press the RIGHT shift button to select “ON”.
1 Displaying the source image (image from the input signal)
7 Press the SET
SET
button.
, “CHANGE : OK/CANCEL” is selected.
, When changing the setting, select “CANCEL”.
8 Press the SET
SET
button.
, The MAIN MENU is displayed.
9 Press the SET
SET
button.
, “SAVE PRG 1/2/3” is selected.
, This menu is used to store the setting in any one of 3 programs (1, 2 or 3).
A Press the RIGHT
or LEFT shift button to select the program number 1, 2 or 3 to store the setting.
, The setting will be overlaid. In case of keeping the stored program, do not select the program No. in which the setting is
stored.
8. Printing Procedures (Special prints)