Filter
Top Products
71
8. Printing Procedures (Special prints)
, When “MODE” is set to “SAME”, or “MODE : DIFF” and “IMAGES” is set to 2(or 2s), only one image is displayed on the monitor
screen.
1 Press the DISPLAY button to display the set conditions.
2 Press the MONITOR button. Select source image (“LIVE” is displayed on the monitor.) to display the image to be stored in
memory.
3 Press the MEMORY PAGE button to select the memory page to store the image.
, The selected memory page is indicated in green in [A B] or [A B C D].
, When the MEMORY PAGE button is pressed, the position to store the image is switched. The switched position is indicated
in green in [A B] or [A B C D].
, Select the previous character of the page where the image is to be stored.
(Select “C” to store the image in page B. The initial setting is “PAGE INC : ON”.)
, When “MODE” is set to “SAME” :
FRAME ..... Select [A] or [B]
FIELD ...... Select [A] [B] [C] or [D]
, When “MODE” is set to “DIFF” and “IMAGES” to “2”(or 2s) :
FRAME ..... Select [A] or [B]
FIELD ...... Select [A] or [B] , or [C] or [D]
4 Press the MEMORY button to store the image in memory.
, When pressing the MONITOR button, selecting MEMORY (memorized image) and then pressing the MEMORY PAGE
button, the image stored in memory can be checked.
1 Printing the images
When “MODE” is set to “SAME”, or “MODE” is set to “DIFF” and “IMAGES” to 2(or 2s)
1 Press the MONITOR button to display the memorized image. (“MEMORY” is displayed on the monitor.).
, In the following cases, select the memorized image to be printed by pressing the MEMORY PAGE button.
1. “MODE” is set to “DIFF” and “IMAGES” to “2” or “2s”.
2. “IMAGES” is set to “4” and FIELD mode is selected.
3. “MODE” is set to “SAME”.
, The selected memory page is indicated in green in [A B] or [A B C D].
, When selecting any one character in [A B] or [C D], [A B] or [C D] is selected.
2 Press the PRINT button.
, The memorized multi-image is printed.
Note :
, When 2 images are printed on a S size paper, comments may not be fully printed.
, When 2 images are printed on a L size paper, the images may not be fully printed.
In this case, adjust the position of the images by “V POSITION” of “4. PRINT SETTING” of “4. PRINT SET” in memory SW
menu.