Mitsubishi Electronics CP700E VCR User Manual


 
30
6. Printing Procedures (Basic prints)
Signal Set Menu
CHANGE : OK
Main Menu
2.SIGNAL SET:PUSH[>]
Main Menu
SAVE PRG: 1
5 Press the SET
SET
button .
, “CHANGE : OK” is selected.
, When changing the input signal selected at step 4, press the RIGHT
button to select “CANCEL” . Press the SET
SET
button to
select “INPUT” in “2. SIGNAL SET” again.
6 Press the SET
SET
button.
, The MAIN MENU is displayed.
7 Press the SET
SET
button.
, “SAVE PRG 1/2/3” is selected.
, This menu is used to store the setting in any one of 3 programs
(1, 2 or 3).
8 Press the RIGHT
or LEFT button to select the program
number 1, 2 or 3 to store the setting.
, The setting will be overlaid. In case of keeping the stored program, do
not select the program No. in which the setting is stored.
9 Press the SET
SET
button.
, The source image (image from the input signal) is displayed.
, The selection of input signal is completed.