Filter
Top Products
10 Hookups (cont’d)
Connecting to a TV Only
TV has only an Antenna In jack
1
Connect your Antenna or Cable TV signal to the ANTENNA jack on
the rear of the Recorder. Your antenna or Cable TV signal may have been
connected to your TV already. If so, disconnect it from the TV and connect it
to the Recorder’s ANTENNA jack.
2
Connect the supplied RF coaxial cable to the TV jack on the rear of
the Recorder. Connect the other end of the same RF coaxial cable
to the Antenna In jack on your TV. Your TV’s Antenna In jack may be
labelled RF In,Antenna In, or 75 ohm. Check your TV’s manual for details.
3
Connect the supplied power cord to the MAINS ~ (AC Power) jack
on the rear of the Recorder.
Connect the power cords of the Recorder and the TV to a power
outlet.
4
Press STANDBY-ON
yy
on the front of the Recorder to turn it on.
“IS TV ON? CH03” will appear on the Recorder’s display panel the first time
you turn on the Recorder.
5
Turn on the TV. Set it to channel 3. You should see the blue Philips DVD
background picture or the Initial Setup screen. Initial Setup appears the first time
you turn on the Recorder. Go to pages 18-20 to complete the Initial Setup.
• The Recorder’s display may
show “IS TV ON? C04” instead.
If so, put the TV on channel 4.
• If you need to use TV channel 4
but “IS TV ON? C03” appears
on the display, press and hold
the Number 4 button on the
Recorder’s remote. After several
seconds, the display will change
to “IS TV ON? C04.” Set your
TV to channel 4.
Likewise, if the display shows “IS
TV ON? C04” and you need TV
channel 3, press and hold the
Number 3 button.
Use this procedure while the
Recorder is on and “IS TV
ON?...” shows on the display.
Helpful Hints
S-VIDEO
(Y/C)
ANTENNA
TV
S-VIDEO
(Y/C)
VIDEO
(CVBS)
VIDEO
(CVBS)
COMPONENT
VIDEO
AUDIO
COMPONENT
VIDEO
AUDIO
Y
P
B
P
R
Y
P
B
P
R
IN - EXT 2 IN - EXT 1
OUT 2 OUT 1
480p/480
i
COAX OUT
G-LINK
DIGITAL AUDIO OUT
OPTICAL OUT
MAINS
AUDIO
L
R
AUDIO
L
R
Antenna or
Cable TV
Signal
Back of TV
(example only)
DIGITAL AUDIO OUT