Filter
Top Products
31
O Browse through the pages of the list using O , N .
a My brand is not included in the list
b Select 'Satellite' and as provider 'No provider'.
You will see a list of all stored brands.
b If you do not find your brand, please proceed as follows:
- Select 'None'. You will find this setting at the end of the list.
- Tune your external receiver to the TV channel which transmits the
GUIDE Plus+
®
data (see table in the section 'General information'). If
this TV channel is available at the internal tuner of the DVD-recorder,
select this channel.
- Wait till the GUIDE Plus+
®
data is loaded (24 hours) and search for
your brand again.
The control data of the external receivers are automatically updated
(completed) via the GUIDE Plus+
®
system in few weeks. This is done
through the aerial, the cable, or the external receiver. You do not need
to bring the device to a service centre.
- If your brand is still missing, note the type and manufacturer of your
external receiver and call the customer support service in your country.
You will find the telephone number on the back of this instruction
manual.
8 Press OK .
9 Select the input socket of the DVD recorder to which the receiver
is connected.
a My external receiver is connected only via aerial cable
- Press O to move to the next page.
Confirm 'Antenna (RF lead)' using OK .
- Enter the channel number under which the external receiver is stored
in the DVD recorder. (e.g.: channel number 'P 04'). Use the number
buttons 0..9 ,or B , A , D , C .
If the external receiver is not allocated to a channel number, you must
search and store it in the DVD recorder as if it were a new TV
channel. Read section 'Search TV channels manually'. Please make
sure that the receiver remains switched on during search and, if
necessary, switch it on to a 'test signal'.
0 Confirm with OK .
Connecting GLINK™ transmitter
The external receiver (satellite receiver, set-top box, cable TV box) is
controlled via the DVD recorder with the G-LINK cable (supplied).
This means you can record TV shows that are received only through
the external receiver.
Connection of the G-LINK cable enables the GUIDE Plus+
®
system to
show the correct guide listing.
1 Connect the G-LINK cable to the G-LINK socket at the back of
the DVD recorder.
2 Position the G-LINK transmitter in front of the external receiver
so that the control signal (IR signal) can be transmitted and
received by the receiver unhindered.
How do I find the right position?
If the position of the remote (IR) receiver is indicated on your external
receiver (IR, remote sensor, or such like), place the transmitter about 1
to 10 cm in front of it.
If the position is not indicated, proceed as follows:
- Switch off the external receiver.
- Point the remote control at the front of the external receiver.
- Move the remote control slowly along the front while repeatedly
pressing the on/off button.
- When the external receiver switches on or off, you've found the
receiver.
- Attach the G-LINK transmitter about one to 10 cm in front of it.
3 Switch the receiver on and select programme number 02 on the
receiver or using its remote control.
ENGLISH
The GUIDE Plus+® System