Filter
Top Products
72
'Direct rec.'
If a recording starts while the DVD recorder is switched off, the TV
channel currently selected on the TV set will be compared with the TV
channels stored in the DVD recorder.
- If the TV channel is found, recording will start.
- If the TV channel is not found, a message will appear on the screen
and in the display.
O 'On':
Direct Record is activated.
O 'Off':
Direct Record is deactivated.
'Filter'
Here you can choose between:
I can not select this function
Check the actual record mode selected. This function is available in the
record modes 'M4'to'M8' only.
O 'Sport':
Picture quality is optimised for rapid movements in the
recording modes (picture qualities) M4 to M8.
Please observe that this setting will reduce the overall
impression of the picture quality.
O 'Normal':
Better overall picture quality.
Please observe that this setting may cause picture artefacts
(MPEG artefacts) to appear in rapid movements.
'Safety Slot'
Here you can enter a time (one to five minutes) when a programmed
recording (Timer) should start earlier and end later. This could be
necessary if the information from the GUIDE Plus+
®
system about the
start and stop time always differ from the actual start and stop time.
'Set up'
SYSTEMMENU
System
Setup
Autodelete
Jumpforward
Jumpback
Installation
FlushBuffer
'System'
In this menu, you can select one of the following features:
'Auto delete'
If there is no space for new recordings on the HDD, you can
determine here whether recordings will be automatically deleted or
not. You can see the titles and the sequence according to which they
will be deleted in the 'Delete Order' setting in the media browser. For
more information, read the chapter 'The Media Browser'.
O 'On':
Recordings will be automatically deleted in the following
order:
1) Titles that have already been viewed. Symbol '
E'.
2) Titles that were not protected. No symbol '
F' available.
O 'Off':
No recordings will be automatically deleted.
'Jump forward'
Set the time you want to jump forward when you press JUMP
FWD in the time shift buffer.
'Jump back'
Set the time you want to jump backward when you press JUMP
BACK in the time shift buffer.
Use the setting 5 minutes for Jump forwardand 1 minute for
'Jump back', to make it easy to skip unwanted scenes.
User preferences for the HDD