Filter
Top Products
75
O 'S-Video'
Only the S-Video signal will be processed at both scart sockets
( EXT1 TO TV-I/O output socket and EXT2 AUX-I/O input
socket).
In case the scart socket of the TV set is not suitable for
S-VIDEO (Y/C) signals, you will only see a black&white
picture, although the recording will be made in colour.
Moreover, only the video (CVBS, FBAS) signal will be used for
recordings via the EXT1 TO TV-I/O scart socket.
Please observe that when making recordings from a video
recorder that transmits only video (CVBS/FBAS) signals
through the scart cable, recordings via scart socket EXT2
AUX-I/O may be made in black and white.
Therefore, use this setting with caution.
O 'CVBS only'
Only the video (CVBS/FBAS) signal is transmitted, regardless
of the video signals (RGB, Y/C) at the scart sockets. This
setting is selected automatically when no 'RGB' or 'S-VIDEO'
signal is detected at the scart socket.
When selecting the settings 'S-Video'or'CVBS only', the RGB signal
is switched off.
The 'RGB' signal is switched off.
O 'S-video + YPbPr'
Component Video (YUV) and S-Video(Y/C).
GUIDE Plus+
®
menus only available on YUV ouput sockets.
O 'CVBS + YPbPr'
Component Video (YUV) and Video (FBAS/CVBS).
GUIDE Plus+
®
menus only available on YUV ouput sockets.
With all other settings, the signal is switched off at the
COMPONENT VIDEO OUT sockets. This will also be displayed
as information on the screen.
Sound settings
You can select the settings in this menu depending on which audio
outputs are used.
If you only use the analogue audio output (red and white socket
AUDIO OUT L/R ), select the setting 'Off' in the 'Digital output'
menu.
Sound
Digitaloutput All
Analogueoutput Stereo
Nightmode Off
'Digital output'
You can select one of the following settings for devices that are
connected to the COAX OUT or OPTICAL OUT sockets:
O 'All'
Dolby Digital and DTS signals are fed unaltered to the digital
output. MPEG-2 multi-channel signals are converted to PCM
(Pulse Code Modulation).
For receivers/amplifiers with digital multichannel
decoders.
O 'PCM only'
Digital and MPEG-2 multi-channel signals are converted to
PCM (Pulse Code Modulation). For receivers/amplifiers
without digital multichannel decoders.
O 'Off'
Digital output switched off.
For devices with analogue audio input.
'Analogue output'
You can select one of the following settings for devices that are
connected to the analogue audio output ():
O 'Stereo'
For devices without DolbySurround or TruSurround. Use this
setting if the DVD recorder is only connected to a stereo TV
set.
O 'Surround'
Dolby Digital and MPEG-2 multi-channel are mixed down to a
Dolby Surround-compatible two-channel output signal.
For devices with Dolby Surround / Pro Logic Decoder .
'Night mode'
Night mode optimises the sound for playback at low volume. You are
therefore less likely to disturb your neighbours. This only works with
Dolby Digital audio on DVD video discs.
ENGLISH
Additional user preferences