Filter
Top Products
33
What must I pay attention to when installing an external
receiver for the first time?
•) The receiver must be switched on.
•) If you can switch between 'TV' and 'Radio' on the receiver, select 'TV'.
•) Select the TV channel that transmits the GUIDE Plus+
®
data on the
receiver. You will find the corresponding TV channel for your country in
the table in section 'General Information' in chapter 'The GUIDE Plus+
System'.
•) On the DVD recorder, select the programme number of the input
socket to which the external receiver is connected:
'EXT2' Scart socket at the back of the DVD recorder EXT2
AUX-I/O
'EXT1' Scart socket at the back of the DVD recorder EXT1 TO
TV-I/O
•) If the external receiver is only connected to the aerial socket, you
must select the programme number on the DVD recorder under which
the external receiver is stored.
•) The DVD recorder must be switched on.
•) If GUIDE Plus+
®
data were loaded, switch the DVD-Recorder off with
the STANDBY m button for approx.10 minutes. During this time,
the data will be stored in a memory to prevent them from being erased
in case of malfunction (power failure).
You must observe this information only when installing the receiver for
the first time. At this point, there is no GUIDE Plus+
®
data available yet
in order to automatically detect the TV channel that delivers the GUIDE
Plus+
®
data.
Using the GUIDE Plus+
®
System
General
The GUIDE Plus+
®
System provides you with a free on-screen listing
for all the TV channels in your location. You can also use it to control a
connected external receiver (satellite receiver, set top box, cable box).
The information of the GUIDE Plus+
®
System is divided in six screen
components:
•) Function buttons (colour panels) along the top of the screen. These
correspond to the colour buttons of the remote control
•) The video window
•) Programme information or instructions for use
•) A line for the selection of available GUIDE Plus+
®
menus
•) The channel guide with the current listings
•) Advertising information or instructions on the GUIDE Plus+
®
system
Calling up the GUIDE Plus+
®
System:
Press GUIDE/TV on the remote control.
Closing the GUIDE Plus+
®
System:
•) Press GUIDE/TV to leave the GUIDE Plus+
®
System and continue
viewing the program you were viewing before you called up the GUIDE
Plus+
®
System.
Using the buttons on the front of the DVD recorder
Calling up the GUIDE Plus+
®
System: GUIDE button.
Closing the GUIDE Plus+
®
System: GUIDE button.
Confirm the function: OK button.
Red function button: n button.
Cursor buttons: UP , DOWN , LEFT , RIGHT .
The navigation in the GUIDE Plus+
®
System
Press GUIDE/TV to view the main menu. Press A to select the
menu line. You can select one of the following functions with D or
C . Press at the desired function the B button for confirmation.
O 'Grid':
Standard GUIDE Plus+
®
system screen (programme guide)
O 'Search'
TV shows sorted by category (movies, sport, etc.)
O 'Schedule':
Scheduled (pre-programmed) recordings
O 'Info':
Additional special functions in the GUIDE Plus+
®
system.
O 'Editor':
Display/Change the channel settings for the 'Grid' screen
O 'Setup':
For changing the basic settings. Read further information in the
chapter 'Set up the GUIDE Plus+
®
System'.
ENGLISH
The GUIDE Plus+® System