Filter
Top Products
23
Chapter 2
Installation Overview
The list and diagrams below briefly describe the sequence of actions required to
hookup your system and prepare to gather data. Refer to the indicated references
for more detailed information.
Action Reference
1. If the system components have not already been unpacked, unpack
them and inspect their carton(s) and the system components for in-
transit damage.
Chapter 3, page 25
2. Verify that all system components have been received. Chapter 3, page 25
3. If the components show no signs of damage, verify that the
appropriate fuse has installed in the Temperature/Power Supply
unit.
Chapter 3, page 26
4. Verify that the appropriate line voltage and fuses have been
installed in the High Voltage (HV) power supply unit.
HV supply unit manual
(IIC-100, IIC-200, IIC-300,
MCP-100...).
5. If the WinView/32 software is not already installed in the host
computer, install it.
WinView/32 manual
6. If the appropriate interface card is not already installed in the host
computer, install it.
Chapter 3, page 30
7. Mount the camera. Chapter 3, page 28
8. With the Temperature/Power Supply unit power turned OFF,
connect the Camera-Power Supply cable to the rear of the
Temperature/Power Supply unit and then to the rear of the camera.
Secure the cable.
Chapter 3, page 31
9. DANGER. With the Temperature/Power Supply unit power and
the HV supply unit turned OFF, connect the high voltage cable,
provided with the system, to the Intensifier H.V.P.S connector on
the HV supply and on the image intensifier housing. Cable
connections must be fully tightened down to prevent arcing.
Chapter 3, page 32
10. On the HV supply, set the MCP Gain to 0 gain (fully
counterclockwise) and set the SHUTTER/GATE switch to GATE,
the AUTO BRIGHT CNTRL ON/OFF switch to OFF, and the MCP
POWER/OFF switch to OFF
HV supply unit manual
11. Connect the cables from the HV supply unit to the timing generator,
trigger source and camera controller as appropriate to your
application.
HV supply unit manual