Filter
Top Products
INSTALLATION AND CONNECTIONS3
INTRODUCTION
10 English
(1) Push in the lock pin with a flat-blade screwdriver.
(2) Insert the cable.
(3) Pull out the lock pin with a flat-blade screwdriver.
The cable is now fixed in place.
The VA-SW804 application software (sold separately) or
the VA-SW80LITE application software (accessory) lets
you control the digital video recorder, and monitor live
images, recorded images and audio through a network.
1 When you have finished making all the
other connections, insert the power
plug into the wall outlet.
There is no power switch. The display indicators flash, and
after a few moments, the monitor screen displays the
camera image.
z When turning the power ON for the first time
“PLEASE SET THE CLOCK” is flashed on the monitor
screen. Follow the steps on page 14 to set the clock.
z If the clock is already set
The operation display area is displayed.
z If the POWER indicator flashes
The digital video recorder has a self-check function that
indicates problems. If there is a problem at power ON or
during operation, the type of problem is indicated by how
rapidly the POWER indicator flashes. Contact a Sanyo
Authorized Service Centre if the POWER indicator flashes.
4 flashes per second:
The disk is checked automatically at power ON. If
a hard disk problem is found, the POWER
indicator flashes, and the hard disk must be
replaced or reformatted. If you need to save
images stored on the disk, contact a Sanyo
Authorized Service Centre.
1 flash per second:
Fan problem
z If you disconnect the power cable
Do not move the recorder or subject it to vibrations for
at least 30 seconds after turning the power OFF.
The disk in the hard disk drive briefly keeps spinning
after power OFF due to inertia, during which time the
head is unstable. At this time, the disk is sensitive to
shocks or vibrations, so avoid even light shocks.
Set the TV SYSTEM selector switch on the rear panel to
“PAL”. (JP. 8)
z Turn the power OFF then ON again after selecting
NTSC or PAL.
Connecting cables to the control and
alarm terminals
Connecting to a network
Connecting the power cord
Cable
Flat-blade screwdriver
PC
SWITCHING
HUB
PC
SWITCHING
HUB
SWITCHING
HUB
SWITCHING
HUB
SWITCHING
HUB
DVR DVR DVR DVR
AUDIO
IN
3
4
1
2
OUT
LAN
1
123456789
1011 12 1314 1516 17 18 19
234
1234
IN
OUT
MONITOR OUT
AC IN
VIDEO
ALL
RESET
ON
NTSC
PAL
TV SYSTEM
RS-485
TERMINATE
OFF
Power cable
* Attach the supplied ferrite core
to the base of the power cable
(coiling not necessary).
*
PAL/NTSC switching
Operation
display area
1
2
3
4
HI A
20-05-03 08 :30:35 AL 00015
e05_l8hbc_hd_6.fm Page 10 Thursday, July 31, 2003 2:51 PM