Filter
Top Products
English 15
3 NORMAL RECORDING/TIMER RECORDING
Follow the steps below to record the monitored image onto
the hard disk.
z When using the recorder for the first time, check that
the TV SYSTEM selector switch on the rear panel is set
to “PAL” correctly. If this switch is set incorrectly,
recording will not be performed correctly. (JP. 8)
1 Press the [REC/STOP] button.
The REC/STOP indicator lights. “REC” appears on the
screen, and recording starts.
z When you record for the first time, the default settings
are used. To change the image quality. (JP. 32)
z When the OVER WRITE recording setting is “ON”, the
DVR starts recording from the beginning again. When it
is “OFF” and the remaining space reaches zero,
recording stops and the FULL indicator lights. (JP. 33)
z You can record and play back images at the same time.
(JP. 17)
z You cannot change the menu during recording.
2 Press the [REC/STOP] button for about
3 seconds.
The REC/STOP indicator turns off and recording stops.
Follow the steps below to record the monitored image onto
the hard disk at the set time.
1 Press the [TIMER] button.
The TIMER indicator lights, and the digital video recorder
enters timer recording standby mode.
z
A warning tone sounds if timer recording has not been set.
(1) See P. 35 for how to set timer recording.
(2) When the time specified in the timer settings arrives,
the REC/STOP indicator lights, “REC” appears in the
screen, and recording starts.
(3) When the set end time arrives, the REC/STOP
indicator turns off, and recording stops.
(4) The following restrictions apply to normal recording
and timer recording.
z After making “PICTURE QUALITY” or “AUDIO
RECORDING” menu settings and returning to the
camera screen, recording does not start for a
maximum of 6 seconds (although normal recording
and timer recording operations can be made).
z After recording finishes (the REC/STOP indicator
turns off), recording does not start for a maximum of
10 seconds (although normal recording and timer
recording operations can be made).
z When the remaining memory space for recording
reaches zero, recording stops, and the FULL indicator
lights. You can start recording from the beginning again
by changing the “OVER WRITE” setting. (JP. 33)
z You can record and play back images at the same time.
(JP. 17)
2 Press the [TIMER] button.
The TIMER indicator turns off and recording stops.
[REC/STOP] button
FULL indicator
[TIMER] button
Normal recording
Ending normal recording
Recording symbol
1
2
3
4
REC H I A
20-05-03 08:30:35
Timer recording
Stopping during timer recording
1
2
3
4
HI A
20-05-03 08 :30:35
e00_l8hbc_hd_6.book Page 15 Wednesday, July 30, 2003 2:34 PM