Filter
Top Products
Lamp Usage Time
Using an RGB monitor loop-out adaptor (sold separately) and an RGB cable (commercially
available), be sure to set to “ Yes (Y Cable)” when you want to display computer images
both on the projector and on a monitor.
Using an RGB Monitor
Loop-out Adaptor
Select “Monitor Out” in the “Options (1)”
menu on the menu screen.
➝
For operating the menu screen, see
pages 50 and 52.
➝
For operating the menu screen using
the GyroRemote see pages 54 and 55.
Note
•Be sure to set to “ Disable” when not
using an RGB monitor loop-out adaptor.
•If the setting is not correct, the image may
be dark, too bright or whitish. This does
not indicate malfunction.
•Make sure to set to “
Yes (Y Cable)”
when using the RGB monitor loop-out
adaptor.
Using an RGB Monitor Loop-out Adaptor
Confirming the Lamp
Usage Time
This function allows you to check the lamp us-
age time.
Select “Options (2)”
menu on the menu
screen to see the lamp usage time.
➝ For operating the menu screen, see
pages 50 and 52.
➝ For operating the menu screen using
the GyroRemote see pages 54 and 55.
Note
•It is recommended that the lamp be
changed after approximately 1,900 cumu-
lative hours of use.
For lamp replacement, contact your near-
est Sharp Authorized Projector Dealer or
Service Center.
Displaying the Lamp Usage Time
-96
PG-M25X#E#p78_96.p65 02.4.29, 3:22 PM96