Filter
Top Products
Introduction
-19
Calibrating the
GyroRemote
If there are any extreme temperature changes
when the GyroRemote is being used or after
batteries have been replaced, the mouse
cursor or pointer may continue to move by
itself even if no action has been performed. In
this case, calibrate the GyroRemote using the
following procedure.
1 Double click on the rear
of the GyroRemote.
2 Make sure that the LED
indicator is lit, and place the
GyroRemote on a leveled
location.
•After leaving the GyroRemote for 6
seconds, the calibration of the
GyroRemote is complete.
3 Press , after leaving the
GyroRemote for more than 6
seconds.
•Calibration is complete after the
remote has been left for more than 6
seconds.
GYRO ACTIVE
button
PG-M25X#E#p08_20_a.p65 02.4.29, 4:56 PM19