Filter
Top Products
48
TV Program Recording
EDIT
100
OPEN/
CLOSE
POWER
SKIP
SEARCH
AUDIO
TIMER
ON/OFF
TITLE
MENU
ANGLE
SETUP/
FUNCTION
DNR
RETURN
REV FWD
SET/
ENTER
VCR PLUS
+
TIMER PROG.
REC MODE
PROGRAM
AM/PM ERASE
STILL/PAUSE
REC
PLAY
STOP
SLOW
SKIP
F.ADV
ORIGINAL/
PLAY LIST
DISC
TIMER
CH
DISPLAY
ON
SCREEN
POWER
INPUT
VOL
CH
TV CONTROL
ZOOM
INPUT
When recording TV programs, an once
recording (from the start of recording until
recording stops) is recorded as a single
“title”.
Basic Recording
VR MODE
DVD RW
VIDEO MODE
DVD RW
DVD R
1
Turn on the TV and switch the TV
channel to the external “VIDEO”
or “AV” channel connected to the
VIDEO/AUDIO output jacks.
2
Press POWER. The recorder is
turned on.
3
Press OPEN/CLOSE to open the
disc tray.
4
Load the disc onto the tray.
• Hold the disc without touching either
of its surfaces, position it with the
printed title side facing up.
5
Press OPEN/CLOSE to close the
disc tray.
• When the disc is being identified
(“LOAD” is displayed on the Front
Panel Display), the DISC IN indicator
on the Front Panel is blinking. The
indicator lights when the disc is
finished being identified (“LOAD”
disappears).
• If you load a completely blank disc,
the recorder takes a short while to
initialize the disc. (It takes around 60
to 90 seconds.)
6
Press CH ' / " to select the TV
channel to record.
• Check whether the channel is set to
the channel you want to record on the
TV screen.
7
Press REC MODE to select the
recording mode.
• Current mode is displayed on the TV
screen and Front Panel Display.
• Each time REC MODE is pressed, the
mode changes as follows:
VR mode:
SP LPFINE EP
Video mode:
SP LPFINE
8
Press ÆREC.
DVD-RW:
Recording starts immediately.
• The recording indicator on the Front
Panel Display lights up.
DVD-R:
The recorder prepares to start recording
when setting “R REC START” in
“RECORD SETUP” to “2 PRESS”. Press
ÆÆ
ÆÆ
ÆREC again to start recording.
• Recording continues until you press
■STOP or the disc is full.
• If you prefer DVD-R recording to work
in the same way as recording to DVD-
RW, set “R REC START” in “RECORD
SETUP” to “1 PRESS”.
Important!
• When you record SAP broadcast, setting
“SAP” in “RECORD SETUP” to “ON” (See
page 87).
DV_RW2U#p45-53.p65 03.1.10, 10:06 AM48