Filter
Top Products
56
VR MODE
DVD RW
• Disc timer recording is a function that lets
you record programming information
directly onto a disc. Since programming
information is recorded onto the disc itself,
recording is programmed simply by
placing the disc in the recorder. It is useful
when recording a particular program either
every week or every day.
• A single disc can be programmed with up
to 8 timer recordings, including daily and
weekly programming.
• When programming recording information
directly on a disc, use a DVD-RW disc that
has been initialized in the VR mode.
1
Press POWER and then load a
DVD-RW disc.
• Timer recording does not work during
loading a disc. Start the timer setting
after the disc is finished being
identified.
2
Press and hold DISC TIMER for
more than 2 seconds.
• The DISC TIMER indicator on the
recorder lights up and the recorder
enters the Disc Timer Recording
mode.
• If a disc that has already been
programmed disc timer recording is
loaded, the recorder enters the Disc
Timer Recording mode automatically.
3
Set the timer recording. (See
“Timer Recording” on page 54 or
“Timer Recording with VCR
Plus+
®
System” on page 52.)
• If a disc that has already been
programmed disc timer recording is
loaded, go to step 4.
4
Press TIMER ON/OFF.
• The recorder is turned off and the
TIMER indicator on the recorder lights
up (Timer standby mode).
• Make sure to check both the TIMER
indicator and the DISC TIMER
indicator light up.
POWER
OPEN/CLOSE
CHANNEL
TIMER ON/OFF
REC
DISC
TIMER
AV
AUTO REC
STANDBY
TIMER
DISC IN
TIMER
DISC
TIMER
Disc Timer Recording
NOTE
• DVD-R discs and DVD-RW discs initialized
in the Video mode cannot be used for disc
timer recording.
• Disc timer recording and standard timer
recording cannot be performed
simultaneously.
• If disc timer recording is set for a disc that
has not been programmed for disc timer
recording, the recorder will not enter the
disc timer recording mode until the disc
has finished being identified.
• In the case of loading a disc in this
recorder for which the disc timer recording
has been programmed with another
recorder, check the contents of the
recording have been programmed since
this recorder has four types of recording
modes.
• When “0h00m” is blinking as the remaining
recording time in the disc information after
disc identification, the disc loaded cannot
be used for recording. Replace it with a
different disc.
EDIT
100
OPEN/
CLOSE
POWER
SKIP
SEARCH
AUDIO
TIMER
ON/OFF
TITLE
MENU
ANGLE
SETUP/
FUNCTION
DNR
RETURN
REV FWD
SET/
ENTER
VCR PLUS
+
TIMER PROG.
REC MODE
PROGRAM
AM/PM ERASE
STILL/PAUSE
REC
PLAY
STOP
SLOW
SKIP
F.ADV
ORIGINAL/
PLAY LIST
DISC
TIMER
CH
DISPLAY
ON
SCREEN
POWER
INPUT
VOL
CH
TV CONTROL
ZOOM
INPUT
DV_RW2U#p54-61.p65 03.1.9, 7:39 PM56