Filter
Top Products
48
Automatic Editing
Chapter 5 Assemble Editing
For details on setup menu item 001, see page 63.
5-2-4 Preview
When you have set the edit points, the PREVIEW indicator
flashes in the menu display area. While the indicator is
flashing, press the PREVIEW function button together
with the SHIFT button. The PREVIEW indicator stays lit,
and preview is performed.
Modify the edit points, if necessary, and perform preview
again.
For details of modifying edit points, see “5-2-2 Modifying
and Deleting Edit Points” on page 46.
To stop the preview
Press the STOP button. The tape stops where it was when
you pressed the button.
To return the tape to the preroll point
Press the PREROLL button.
To return the tape to the IN point or OUT point
Press the PREROLL button together with the IN or OUT
function button on the P5 EDIT page of the function menu.
Monitor output
During a preview, on a monitor connected to the recorder
you can monitor the following video and audio:
• From the preroll point to the IN point, you can monitor
the playback from the recorder VTR.
• From the IN point to the postroll point, you can monitor
the playback from the player VTR through the recorder
VTR in E-E mode.
The figure below illustrates this.
PB (Recorder) E-E (Player) E-E (Player)
IN point OUT point