Filter
Top Products
67
Items in the Extended Setup Menu
Chapter 9 Setup Menus
a) Not applicable in 24PsF/23.98PsF mode
Items 200 to 299: Settings for the remote control interface
120 CTL LOCK IN SHTL Select whether the tape transport should be phase-locked to the CTL signal during
playback in shuttle mode.
OFF: Not phase-locked
[ON]: Phase-locked
125 AUTO REWIND Select whether to rewind the tape automatically when recording or playback reaches
the end of a tape.
DIS: Do not rewind the tape automatically.
[ENA]: Rewind the tape automatically.
130 TIMER DISPLAY DIMMER
CONTROL
Set the brightness of the display window.
100% [75%] 50% OFF
137 TRACKING CONTROL VIA
JOG/SHUTTLE DIAL
Select whether the search dial is enabled for tracking control.
[OFF]: Disabled the tracking control
ON: Enabled the tracking control during playback
138 STOP CODE FUNCTION Set for detection of the stop code, and recording to a tape.
Note
This is enabled in 59.94i, 29.97PsF mode only.
Sub-item
1 STOP ADJUST Adjust the position to stop the tape when the stop code is detected.
[0F] to 30F
2 REC ADJUST Adjust the position to record the stop code.
1SEC to [3SEC] to 5SEC
140
a)
AREA MARKER Select whether the down-converted SD output signal is displayed in the display window
or not or whether the down-convert mode or up-convert mode is displayed in the display
window or not.
[OFF]: Not displayed
ON: Displayed
144 REW SPEED [MAX]: The tape runs with pinch roller disengaged in rewind mode. This setting
enables high-speed rewinding the tape.
LIMIT: The tape runs with pinch roller engaged in rewind mode. This setting enables
quick changeover between the rewind mode and the other mode.
145 MODE KEY ENABLE
DURING RECORDING
Set the mode buttons enabled during recording.
[ENA]: All mode buttons are enabled.
S&P: Only the STOP and PAUSE buttons are enabled.
147 AUTO CTL RESET Select whether the CTL signal is to be automatically reset upon the tape ejection.
OFF: Not reset the CTL signal
[ON]: Reset the CTL signal
Item
number
Item name Settings
Item
number
Item name Settings
201 PARA RUN Select whether or not to use synchronized operation for two or more VTRs.
[DIS]: No synchronized operation
ENA: Use synchronized operation
Note
To use synchronized operation for two or more VTRs, set item 201 to ENA on all of the
VTRs.
212
a)
VIDEO REMOTE
CONTROL SELECT
Make settings for the control from the HKDV-900 connected to the VIDEO CONTROL
connector (9-pin). Select whether to control the up-converter or down-converter when
controlling the image enhancer.
[DOWN]: Control the down-converter.
UP: Control the up-converter.
U&D: Control both the up-converter and down-converter.
Note
Turning the SETUP dial with the D2 button held down on the HKDV-900 controls the
value corresponding to setup menu item 718 (SETUP LEVEL).