Filter
Top Products
68
Items in the Extended Setup Menu
Chapter 9 Setup Menus
a) Not applicable in 24PsF/23.98PsF mode
Items 300 to 399: Settings for editing
214 REMOTE INTERFACE Select a device which remotely controls this unit.
[9PIN]: A device connected to the REMOTE 9P connector
SDI:A device connected to the HD SDI connector
Item
number
Item name Settings
Item
number
Item name Settings
305 SYNC GRADE When editing in phase-synchronized mode with menu item 004 set to ON, select the
target phase synchronization accuracy.
[ACCUR]:
±0 frame accuracy
ROUGH: ±1 frame accuracy
307 AUTO-DELETION FOR
INCONSISTENT DATA
Select what happens when an erroneous edit point is set.
[MANU]: A warning is given by flashing the DELETE indicator on the P5 EDIT page of
the function menu. Delete an unnecessary edit point, or set it correctly.
NEG&E: When inconsistent edit points are set, such as when an OUT point is before an
IN point, or when too many edit points are specified, the previously set edit point is
deleted.
NEG: When inconsistent edit points are set, such as when an OUT point is before an IN
point, the previously set edit point is deleted. When more edit points than necessary
are specified, the DELETE indicator flashes to give a warning.
Note
Pressing the function button corresponding to an edit point to be deleted and the
DELETE function button simultaneously deletes the edit point. If an erroneous edit point
is set (the DELETE indicator is flashing), editing is not executed.
309 SERVO/AV REFERENCE
SEL
Select the servo reference signal.
[AUTO1]: During recording, the input video signal is used as the servo reference signal.
During playback, the signal selected by OUT REF on the P2 VIDEO page of the
function menu is used as the servo reference signal. If the signal selected by the
OUT REF setting is not connected, an internal reference signal is used.
AUTO2: When OUT REF on the P2 VIDEO page of the function menu is set to REF, and
ASSEMBLE on the HOME page of the function menu is set to ON, the reference
signal for video/audio signal processing is locked to the input video signal.
EXT: The servo reference signal is forced to be an external reference video input.
318 EDIT RETRY For two-VTR editing, set when this unit is used as the recorder. Selects the operation if
the recorder was not synchronized in time.
OFF: Editing is not carried out, and the unit stops.
[ON]: The editing is automatically retried (up to twice).
326 AUTOMATIC IN ENTRY
AFTER AUTOEDIT
Select whether or not to automatically set the OUT point of the previous edit as the next
IN point at the end of an automatic edit.
[OFF]: No automatic setting
R: Set recorder IN point automatically.
R & P: Set recorder IN point automatically, and also player IN point in two-VTR editing.
334 EE REFERENCE
CONTROL
Sets the method to select the reference video signal in E-E mode.
[NORMAL]: Select according to the table in “3-5 Setting Reference Video Signals” on
page 27.
INPUT: Select an input video signal in E-E mode. In other cases, Select according to the
table in “3-5 Setting Reference Video Signals” on page 27.