Filter
Top Products
24
Using Non-Preset Remote Control
Operations
— Learning Function (continued)
To change the function display of
a key
You can select the most suitable function
display among all the displays the key
has, and set it to the key.
1 After Step 4 (page 21), while
pressing the Mode Display key
(in this case, VCR), press the key
you want to teach repeatedly.
VCR
Each time the key is pressed, the
display is changed in order.
2 When the desired display
appears, release the Mode
Display key.
3 Then follow Steps 6 to 8 (page 22,
23).
Notes
•You can change the display of a key only
when you program it using the learning
function. If you want to change the display of
the key that has learned a signal, clear the
signal first (page 26). Then teach the key
again using the above procedure to change its
display.
• If you do not change the display of a key, the
default display is used.
•You cannot change the display of the area of
the number keys 1 to 9.
To change the name of the Label
key
You can change the display of the Label
key to the most suitable name using up
to 8 characters or digits.
1 After Step 4 (page 21), hold the
Label key of which name you
want to change (for example,
COUNTER) pressed for more
than 2 seconds.
COUNTER
The Commander enters the Label
Input mode.