Filter
Top Products
71
Notes
• If the TEST key or the ON/OFF key is
pressed when the timer program is not set,
the “NG” sound is heard twice and “NG”
flashes.
• When you finish the timer setting mode after
you set the timer standby mode, “c” mark
stays lit beside the clock. This means that one
or more timer programs are set to the timer
standby mode.
• The timer program contents you have set on
this Commander repeat every week until you
set the timer standby mode to OFF (weekly
timer). If you want to execute the timer
program once, set the timer standby mode to
OFF after the execution of the timer program.
IMPORTANT
The timer function of this
Commander is designed for the timer
operation of AV components. Do not
use the timer function to operate an
air-conditioner or electrical
appliances. It may cause a fire or a
serious injury.
2 Select the program number of
which timer standby mode you
want to switch to on by pressing
the Label key.
If you select the program number
which has no timer program data, the
“NG” sound is heard and “NG”
flashes twice.
3 Press the ON OFF key.
With a beep sound, “c” mark lights
and the standby mode of the selected
timer program is set to on. The
display returns to Step 1.
4 Keep COMMANDER OFF
pressed for more than 2 seconds
to turn the Commander off.
To reset the standby mode to off,
follow Steps 1 - 3 again.
To clear timer settings
programmed for a specific PROG
(1 - 12) Label key
1 While pressing COMMANDER
OFF, press MUTING.
Continued