Filter
Top Products
40
Executing a Series of Commands
— System Control Functions
(continued)
To clear a System Control
function programmed for
Component Select buttons and
Label keys
1 Follow Steps 1 - 4 on page 27.
2 While pressing the DEL key, press
the Component Select button (or
Label key) of the System Control
function you want to clear.
To change the Label keys, press the
OTHER button repeatedly.
3 Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the previous
setting mode.
You can select the Label key for
programming a series of commands
by pressing the desired Label key.
To change the component names of
the Label keys, press the OTHER
button repeatedly. Each time you
press the OTHER button, the display
of the Label keys changes as in Step 4
on page 13.
3 Follow Steps 4 to 7 on page 34.
Notes
•You can program the System Control
functions for a Component Select button or a
Label key on which the Power-On function
(page 44) has been programmed. In this case,
the Power-On function is overwritten and
cannot be used. If you clear the System
Control functions for the button, the Power-
On function is resumed, and you can use it
again.
•You cannot program the System Control
functions for a Component Select button or a
Label key for which a signal has been
programmed by “learning” (page 46). (“NG”
flashes on the display.)
•You can program the Power-On function
(page 44) for a Component Select button or a
Label key for which a System Control
function has been programmed, but the
Power-On function cannot be used. If you
clear the System Control function from the
button, you can use the Power-On function.
• If you interrupt the procedure at any point
for over two minutes, the setting mode ends
and the series of commands will be
programmed to that point. In this case, clear
the program and start again from Step 1 to
set the entire program from the beginning.
You cannot continue from where you let off.
• If you change the component code number
(page 12) or program a new signal by
learning (page 20) for a key or button that has
been programmed with the series of
commands of a System Control function, the
new signal will be transmitted when you
press the corresponding Component Select
button or a Label key.