Filter
Top Products
47
Example: To program the input
select signal of your amplifier to
the CD button
1 Place the RM-AV3100 head to
head with your component’s
remote control.
2 Follow Steps 2 and 3 on page 21
in “Learning Function.”
3 While pressing the Mode Display
key (LEARN), press the
Component Select button or the
Label key you want to “teach,”
and release both keys.
(To change the Label keys, press the
OTHER button repeatedly.)
The selected component name
appears on the Mode Display key, and
“LEARN” begins to flash.
4 Press and hold down the button
on the component’s remote
control (in this case, amplifier)
until you hear a beep.
(If you release the button before you
hear a beep, the signal may not be
learned correctly.)
“LEARN” stops flashing and stays lit.
If “NG” flashes on the display
Learning did not succeed. Try Steps 3 and 4
again.
Continued
Remote control of
your component
RM-AV3100
about 2 - 4 inches
(5 - 10 cm) away