Filter
Top Products
57
5 Press the “TRANSFER” key.
TRANSFER
“TRANSFER” appears on the Mode
Display key.
6 Press the X key.
X : Transfer data
x : Receive data
7 Press the ALL key.
ALL
ALL: All data of the Commander
COMPO: Data of a Component
Select button or a Label key
“ALL X” appears on the Mode
Display key, and “ALL” appears on
the left Label key.
8 Confirm that the receiving
Commander is ready for data.
(To set the receiving commander,
follow the procedure on page 59.)
9 Press the “ENTER” key.
During transferring the data,
“
c
c
c
c
c
c
c
c
” flashes.
When the all data has been
successfully transferred, “END”
appears on the right Label key.
Note
If “NG” appears while sending the data, go
back to Step 5 and continue the operation
or press COMMANDER OFF to stop the
operation.
Continued