Filter
Top Products
70
7 Press the OK key.
With a beep sound, the Timer Macro
setting is cleared, and the
Commander enters the Timer Macro
setting mode (Step 7 on page 67).
If you press the NG key
The display returns to Step 5.
Note
You cannot change the Timer Macro setting
partially. If you want to change the
program without clearing the frequently
used procedure, use the System Control
function (page 32). For example, if Steps A
to D are frequently used when you want to
program Steps A, B, C, D and E, program
Steps A to D using the system macro. Then
program Step E in the Timer Macro adding
to that system macro.
With a beep sound, “ON” appears,
and the Commander enters the timer
standby mode. The display returns to
Step 2 on page 65.
To reset the timer standby mode,
press the ON/OFF key again.
3 Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the previous
setting mode.
To check the execution of the
timer program or set the timer
program to the standby mode
1 Follow Steps 1 - 3 on page 65.
2 Press the TEST key or the ON/
OFF key.
TEST: You can check the timer
program setting by transmitting the
Timer Macro signals.
ON/OFF: The display turns as below.
To switch quickly the timer
standby mode to on or off using
the TIMER button
1 Press the TIMER button.
The program numbers of which timer
program is set to the standby mode
stay lit, and the other program
numbers flash on the Label keys.
To change the Label keys, press the
TIMER button repeatedly.
Setting the Timer (continued)